TOPEC DH – Sophisticated extension for sloping slabs
The established TOPEC slab formwork, extended! TOPEC DH introduces a patented drophead to allow for early stripping, even on inclined slabs. This considerably expands the range of applications: Even inclined slabs, ramps and drains with an angle of inclination of up to 8 % can be quickly and safely formed and stripped with standard TOPEC DH components. For ultimate flexibility, panels can be installed from above or below.
Early stripping for greater efficiency
The drophead enables early stripping: the panels can be used again more quickly, while compensators and supports remain in the slab until it has reached sufficient load-bearing capacity. Safe forming is also possible in edge areas, with a wide range of available guardrail solutions. It is possible to use different edge protections.
TOPEC DH is compatible with the proven TOPEC® system, with GASS®, LIGHTSHORE®, EUROPLUS® and ALUMA HD supports.
- Can be used for flat or inclined surfaces such as slabs or ramps with an angle of inclination of up to 8 % - all with standard components
- Less material required thanks to above-average grid of 1.80 x 2.40 m - reduce reshores and labor
- Compensation hooks to prophead - no loose parts during disassembly
- Compatible with the proven TOPEC system, with GASS, LIGHTSHORE, EUROPLUS and ALUMA HD supports
Hünnebeck Deutschland GmbH
Rehhecke 80 | 40885 Ratingen | Tel.: +49 (0)2102-937 1 | Fax: +49 (0)2102 937 37651 | email@example.com